Licensed, insured, and warrantied flat roofing work across Boone County
Flat roof repair Florence KY that stops leaks for good
Flat roof repair Florence KY is what we do when ponding water, seam splits, or storm damage turn your roof into a problem. We serve homeowners and commercial property owners across Florence, Kentucky with TPO, EPDM, and modified bitumen repairs. If water is finding its way inside, we find the source, fix it, and test it before we leave.
Live phone supportUpfront optionsBacked workmanship
What's included
What our flat roof repair includes
Every flat roof repair starts with a full inspection and ends with a flood test. Here is what is covered in a standard repair. If your roof needs a full replacement or a coating system instead, we will tell you upfront and price it separately.
Full leak inspection
We walk the entire roof, check seams, flashing, drains, and penetrations, and use a moisture meter and infrared camera to map how far water has spread. You get photos and a written report.
Membrane repair or splice
We cut out the failed section, replace saturated insulation board, and splice in new TPO, EPDM, or modified bitumen membrane. Seams are primed and rolled or heat-welded to manufacturer spec.
Flashing and seam sealing
Most flat roof leaks start at flashing or seams. We reseal counterflashing, pipe boots, and parapet edges with the correct sealant and membrane tape for your roof system.
Drain and ponding fixes
Standing water kills flat roofs. We clear clogged drains, add or adjust drain locations where ponding is chronic, and verify water flows off the roof after the repair.
Flood test and documentation
Before we leave, we flood-test or hose-test the repair area to confirm it is watertight. You get before-and-after photos, warranty paperwork, and a maintenance note.
Service overview
Flat roof repair Florence KY done the right way
Flat roof repair Florence KY means finding the actual failure point, not just smearing tar over the symptom. On a low-slope roof, water does not run off like it does on shingles. It sits, it creeps, and it finds every seam, fastener, and flashing gap you have. We use a moisture meter and an infrared camera to map wet insulation before we cut anything open. Then we repair the membrane, replace saturated board, and re-seal the seams so the fix holds through the next freeze-thaw cycle.
Most flat roof calls in Florence start with a stain on the ceiling, a soft spot underfoot, or a tenant complaining about drips after a hard rain. The flat roofing repair Florence property owners call us for usually traces back to ponding water on flat roofs, flashing failure at a parapet wall, or hail damage that cracked a membrane two summers ago and only now started leaking. We handle residential flat roofs on garages and additions, plus commercial flat roof repair Florence warehouses and retail buildings depend on.
How we workWe verify the cause, compare realistic options, and confirm the repair before we leave.
The service timeline
How our flat roof repair process works
The process flexes to the condition, but these checkpoints keep decisions clear.
Call and schedule
Call (844) 799-4703 and tell us what you are seeing: a ceiling stain, a drip, a soft spot, or storm damage. We book a same-day or next-day inspection in most of Florence, including 41042 and 41022. You get a window, not a vague all-day promise.
Inspection and leak mapping
We walk the roof, check seams, flashing, drains, and penetrations. A moisture meter and infrared camera tell us how far the water has traveled. On a typical 2,000 sq ft commercial roof, this takes 45 to 90 minutes, and we show you photos of what we find.
Written scope and price
You get a clear scope: what we repair, what membrane we use, and the price. No surprise line items. Most flat roof repairs run $450 to $2,800 depending on how much wet insulation has to come out and whether we are matching TPO, EPDM, or modified bitumen.
Repair day
We set up safely with a roofing ladder and safety harness, cut out the failed membrane, replace saturated board, and install the new section. Seams get primed and rolled. Most repairs take two to six hours, and we clean the site before we leave.
Flood test and walkthrough
Before we call it done, we flood-test the repair area or run a hose test to confirm no water gets through. You get photos of the finished work, warranty paperwork, and a maintenance note on when to check drains and seams next.
Tools & methods
Tools and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Infrared camera
Detects temperature differences that reveal wet insulation under the membrane, so we cut only where water has actually spread.
Moisture meter
Confirms how saturated the insulation and decking are, which tells us whether a repair or replacement is the honest call.
Roofing ladder and safety harness
Gets us on and off low-slope roofs safely and keeps crews OSHA-compliant on every Florence job.
Seam roller and heat welder
Bonds TPO and EPDM seams to manufacturer spec so the repair holds instead of peeling at the edge.
Utility knife and tin snips
Cuts membrane and flashing cleanly for tight, code-correct patches around drains and penetrations.
Use cases
When to call for flat roof repair
These examples show how the service framework adapts rather than forcing every call through one repair.
Retail building ponding fixed in Downtown Florence
A 3,000 sq ft modified bitumen roof had chronic ponding near the rear drain. Two tenants reported ceiling stains, and the property manager had paid for three separate patches over two years. → We infrared-scanned the roof, found the low spot, repaired the membrane, and added a secondary drain. Water now flows off the roof within an hour of a storm. No tenant complaints since the repair.
Warehouse hail damage repaired in South Florence
A spring hail storm cracked the EPDM membrane on a 12,000 sq ft warehouse, causing three active leaks. The owner was worried the whole roof would need replacement and the insurance claim would be denied. → We tarped the leaks the same day, documented the damage with photos and measurements, and met the adjuster on the roof. The claim was approved, and we repaired the damaged sections with new EPDM and heat-welded seams.
Problems we solve
Flat roof problems we fix in Florence
Flat roofs fail in predictable ways, and Florence weather speeds up the process. Here are the problems we see most and how we solve them.
Ponding water sitting on the membrane
We locate the low spot, repair or replace the membrane there, and correct drainage by clearing or adding drains. After the fix, we verify water actually leaves the roof instead of pooling.
Ceiling stains and mystery leaks
We use a moisture meter and infrared camera to trace the water path back to the source. Then we repair the real entry point, not the stain, and flood-test to confirm.
Hail and storm damage to the membrane
We document the damage with photos and measurements, meet your adjuster on the roof, and repair the membrane to pre-storm condition once the claim is approved.
Flashing failure at parapet walls
We remove failed flashing, repair the substrate, and install new counterflashing with proper membrane tie-in and sealant rated for Kentucky temperature swings.
How much does flat roof repair cost in Florence KY?
Most flat roof repairs in Florence run $450 to $2,800 in 2026, depending on roof size, membrane type, and how much wet insulation has to be replaced. A simple flashing or seam repair sits at the low end. A larger TPO or EPDM section with saturated board removal lands higher. You get a fixed written price after the inspection, and the inspection itself is free.
Can a flat roof be repaired in Florence Kentucky?
Yes. Most flat roofs can be repaired rather than replaced, as long as the decking and insulation are still sound. We use a moisture meter and infrared camera to check how far water has spread. If the wet area is contained, we cut it out, replace the board, and splice in new membrane. If more than about 25 percent of the roof is saturated, we will tell you replacement makes more financial sense.
How long does flat roof repair take in Florence KY?
A typical flat roof repair takes two to six hours on site. Small flashing or seam fixes finish in under two hours. Larger repairs that involve cutting out wet insulation and splicing in new TPO or EPDM membrane can run a full day. We schedule most Florence jobs within three to five days of your call, and storm-damage calls get priority.
What is the best flat roof material in Florence KY?
For Northern Kentucky weather, TPO and EPDM are the two workhorses. TPO handles the summer heat and UV better and reflects sunlight, which helps cooling costs. EPDM is more forgiving in cold snaps and has a longer track record. Modified bitumen is common on older Florence buildings and still repairable. The best choice depends on your existing membrane, roof slope, and budget, and we will walk you through it.
Related services
Related Services
Roofing contractor near me
If you are searching for a roofing contractor near me in Florence, we handle flat and pitched roofs across Boone County. Same crew, same license, same warranty on every job.
24/7 roofing service
Flat roofs do not leak on schedule. Our 24/7 roofing service takes emergency calls after storms and overnight, and we tarp or patch to stop water until a full repair can be scheduled.
Local roofing contractor
As a local roofing contractor based in Florence, we know how Boone County weather treats flat membranes. That local knowledge is why our repairs hold through freeze-thaw cycles.Ready when you are
Get your Flat roof repair Florence KY scheduled today
Every flat roof repair we do is licensed, insured, and backed by a written warranty. Call (844) 799-4703 and we will get eyes on your roof, usually the same day. Free inspection, fixed price, no pressure.
Talk with the local team
Request Flat roof repair
Call (844) 799-4703 any time, day or night, and a real person picks up. For standard inspections and estimates we schedule within 24 to 48 hours, and emergency leak calls get same-day priority. You can also email info@revixionlab.com with photos of the problem and we will get back to you with next steps.